On Mon, Jul 20, 2015 at 10:54 AM, Sam Nabkey <sam.nabkey@gmail.com> wrote:
Not sure what you mean by transmitter steering?
Sam, Transmitter steering uses voted receivers to choose the best (single) transmitter. Here is a good explanation: http://www.signalharbor.com/ttt/00oct/ More below... On Mon, Jul 20, 2015 at 11:00 AM, David McGough <kb4fxc@inttek.net> wrote:
Hi Tom,
Do you mean for a multi-site system, steering the activated transmitter to the site where the loudest received signal originates from??? If so, isn't that more applicable for scenarios where you've got a central dispatch center and have clients (cars, etc.) only calling the dispatch? For ham applications, I'd think you'd want to blanket the whole region with a transmitted signal (basically simulcast)?
Yes, this is what I mean. You are right that this is not a typical ham application. The primary use of our repeater is in support of search and rescue. Usually, everyone participating in the search will be in the same general area, and therefore only the nearest receiver and transmitter site need be used. It would be advantageous to reuse the same repeater pair at every site, and the same tone, so users don't have to figure out which repeater is best. Currently, our transmitters do not have a timing reference input, nor do we have a fleet of GPSDOs. Simulcast may be a stage two plan, but at this point I'm looking at transmitter steering, since it will satisfy 99% of our use case. Tom KD7LXL