I have an odd issue with node 46387 which is my portable simplex "Grab & Go" Raspberry Pi Server based node. It worked all summer long while I was running around doing wildfire comm support, used both my cellphone hotspot and over Satellite links. Got it out to use in the shack the other day and it won't dial out (or in)! Set it up on the same LAN that I have another server behind and that it worked on last year. Have no problems with the other two nodes on the other server on that LAN (*45882 <http://stats.allstarlink.org/nodeinfo.cgi?node=45882> & 45685 <http://stats.allstarlink.org/nodeinfo.cgi?node=45685>)* and have a unique port forwarded thru the Router for its Receive but no soap... Shows up on the AllStarLink site as active and can see keyups. One odd symptom is that when monitoring in the Asterisk CLI it indicates that Asterisk is truncating any node numbers that I dial to a four digit ID... i.e. I dial *312345 The CLI shows *31234 and will not accept the fifth digit. It is not a DTMF decode issue as if I dial a nonsense code like *512345678 The CLI shows all the digits...??!! The voice telemetry all works fine and the response even for a four digit node ID (like *32560) is a long (15-20 second) pause then "Node XXXX Failed to connect." Been digging thru all the .conf files and comparing to my other nodes, No obvious (To me.) differences. Oh and Yes I've done a full update and I can ping 8.8.8.8 and Google.com with success. I'm about to just blow it out and start from scratch. Thanks in advance. Ray D. Congdon - KL7UT