Hi Jim,
Well, sorry but *WRONG!!!*. 1200 packet mode rolls off the low side of the audio spectrum and makes CTCSS decoding completely impossible. Its not too happy with the high side of the spectrum and the squelch detection either. Thats why I was forced to use 9600 and having to give it a signal higher then the Alps.
For remote operation it already worked in 9600-mode (without the amplifier, but with txboost=1) using the iaxRpt-client with a high mic-in level (+mic boost). However using this client audio level with a standard repeaeter is much too loud... So I will try 9k6+amp next weekend. I have another question about the default shift on 70cm. I set it to -7.6Mhz for german repeaters on the radio. After I logged in with the iaxRpt-client asterisk will change it back to 5MHz for 70cm (and will jump to 2m 146.580...). I didn't found any documentation about the memory stanza in rpt.conf. Using "-" or "+" will use the default shift. Is it possible to add a shift for each memory? Tnx, 73, Jann