I think I am using the Limey Linux for i686. I am trying to remember if I used 'dd' or 'gunzip -c.....' to install the image to the IDE flash drive. I remember having some trouble first installing it, but decided to try a couple different routes as previously I had to do the same thing. I am not sure why I had to do that, but I figured there are more than one to do something. ~Benjamin, KB9LFZ On Thu, 2013-06-27 at 22:28 -0500, Robert Garcia wrote:
Benjamin,
Which image of Limey are you running? Both of them panic on me.
Robert
On Tuesday, June 25, 2013, Robert Garcia wrote: I have 5 of the Neoware CA22 systems on the way, so wish me luck!
Robert N5QM
On Mon, Jun 24, 2013 at 7:39 PM, George Csahanin <george@dyb.com> wrote: > I have standardized on the Intel D945 motherboard in a M200 case from Mini > Box. 1GB RAM and a 256MB CF and use Limey. Limey can be customized for other > motherboards. The power supply is tricky. I found the cheapies convert the > 12V in to 5 volts. But they tend to take the 12 volts in and make that the > 12 volts for the motherboard (P4 4 pin connector) Any wiggle on that 12 > Volts and the computer does really crazy stuff. Mine would just shut down. > So thru trial and error I found the PICO PSU 60-WI 60 watt power supply. The > input can go down to about 7 volts and the 5 and 12 volt supplies are > steady. Runs very stable. > > One drawback of this motherboard is the USB system. If you use SimpleUSB, > it's great. USBRadio, not so good. Lots of audio interruptions that last > miulliseconds. For voice, not a problem. But if you're using it to decode PL > and squelch it just will not work well. I'm told other motherboards (read: > non-Intel) would be better. But I have about 7 of these now, not going to > change. But the printer port is important to me. So I didn't need to hack > the USB Fob I use pp signalling. Getting ready to add remote base to it in > the coming weeks. > > GeorgeC > W2DB > AllstarLink 2360 > > > ----- Original Message ----- From: "Robert Garcia" <robert@n5qm.com> > To: "APP_RPT" <app_rpt-users@ohnosec.org> > Sent: Sunday, June 23, 2013 8:50 PM > Subject: [App_rpt-users] Small System Recommendations > > > >> All, >> >> I am looking for recommendations on small, preferably inexpensive, >> systems that are capable of running on 12v to take advantage of the >> redundant power systems at our sites. >> >> I would like it to support at least two nodes running simpleusb as I >> don't need the DSP processing capabilities. The idea is that these >> systems would be connected to a port on an existing controller. >> >> I expect that HP thin clients are going to be my best bet, but there >> seem to be many different models so I don't know where to begin. >> >> Suggestions or thoughts? >> >> Robert >> N5QM >> >> > _______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users