2 questions.... Are you using a HamVOIP image ? if not Did you place a hold on the kernel headers before applying updates ? http://dvswitch.org/files/ASL_Images/Raspberry_Pi/Stretch/ASL_1.01-20180228-... Login: repeater Passsword: allstarlink SSH port: 22 User repeater has sudo privileges (sudo -s) There may have been updates to the operating system and AllStarLink since this image was built. Run the following commands after the first time you boot. sudo apt-mark hold raspberrypi-kernel-headers raspberrypi-kernel sudo apt-get update sudo apt-get upgrade -y sudo reboot at the # prompt run "asl-menu" to setup your node. ...mike/kb8jnm On 3/22/2019 4:35 PM, George Csahanin wrote:
OK folks. I've tried everything I know how to do to recompile asterisk with my mod to app_rpt.c and am at wit's end. Just tried fresh today on a fresh install of the Allstarlink 1.01 on a Pi3 (the distro works fine). I made sure that gcc and g++ 4.9 were installed. Then did:
git clone https://github.com/AllStarLink/Asterisk.git
Then in asterisk/ did ./configure CXX=g++-4.9 CC=gcc-4.9
Then did make
Blows up. Needed to delete menuselect.makeopts (not unusual) so deleted and start over.
Blows up at need termcap...I re-installed libncurses-dev
Gets past that and blows up at chan_pi, go into menuselect and unselect pi, try again
Blows up now at chan_beagle, unslect that and try again
Blows up at chan_simpleusb, unselect try again
Blows up at:
Makefile:361:recipe for target "main" failed
Running this as root. Also for grins (assuming a permissions issue) did chmod -R 777 *
Didn't help.
The README says this is what was used to make 1.01
WHAT am I doing incorrectly??
Used to be I'd recompile asterisk with zero issues.
Can anyone give me any pointers?
GeorgeC W2DB 2360, 28599, etc