copy to /etc/asterisk/rpt.conf (below node#) aka first section. outstreamcmd=/bin/sh,-c,/usr/bin/lame --preset cbr 16 -r -m m -s 8 --bitwidth 16 - - | /usr/bin/ezstream -c /etc/ezstream.xml cp: cannot stat `ezstream.xml': No such file or directory cp: `bin/awk' and `/usr/bin/awk' are the same file cp: `bin/cut' and `/usr/bin/cut' are the same file cp: `bin/env' and `/usr/bin/env' are the same file cp: `bin/gawk' and `/usr/bin/gawk' are the same file cp: `bin/gettext' and `/usr/bin/gettext' are the same file cp: `bin/gunzip' and `/usr/bin/gunzip' are the same file cp: `bin/gzip' and `/usr/bin/gzip' are the same file cp: `bin/kill' and `/usr/bin/kill' are the same file cp: `bin/ksh' and `/usr/bin/ksh' are the same file cp: `bin/logger' and `/usr/bin/logger' are the same file cp: cannot stat `share/man/man1/*': No such file or directory cp: cannot stat `/share/doc/ez*': No such file or directory Followed these directions below.. 1.) Extract the attached file EZS.tgz 2.) Run 'sh EZS' 3.) Agree to everything - yes 4.) Modify the /etc/ezstream.xml file - replacing the ######'s with the correct mount point/password/name of your stream. (These details are provided by radioreference.com when you sign up to do a stream FREE (under the "Technicals" tab in the stream management section.) 5.) add the following to your /etc/asterisk/rpt.conf in the first section ex: above the status reporting section. "outstreamcmd=/bin/sh,-c,/usr/bin/lame --preset cbr 16 -r -m m -s 8 --bitwidth 16 - - | /usr/bin/ezstream -qvc /etc/ezstream.xml" *This should be all on one line ^^^* You may change the ezstream.xml name if you wish but also do so in the /etc dir, ex: if you had multiple streams/nodes to stream from. This setup is per node. btw sometimes I have had to set a cron to kill the ezstream each week or so - has not been an issue lately if you do notice it failing, the command is 'kill -9 $(pgrep ezstream)&' This will not break/stop ezstream but should restart it... Here is example of what it looks like in rpt.conf [29925] ; Change this to your assigned node num$ rxchannel=Radio/usb29925 outstreamcmd=/bin/sh,-c,/usr/bin/lame --preset cbr 16 -r -m m -s 8 --bitwidth 16 - - | /usr/bin/ezstream -c /etc/ezstream.xml duplex=2 Example of node number two same config [27103] ; Change this to your assigned node num$ rxchannel=Radio/usb27103 outstreamcmd=/bin/sh,-c,/usr/bin/lame --preset cbr 16 -r -m m -s 8 --bitwidth 16 - - | /usr/bin/ezstream -c /etc/ezstream2.xml duplex=2 Ez stream still not working even with the correct information in the ezstream.xml files located in /etc/ Kinda lost now what steps i have missed.. Loren Tedford (KC9ZHV)