thanks , this helps 100% Going to try and build the cable after supper , and then connect it to the repeater One step at a time Thanks for all the help Richard Szajkowski
On Oct 20, 2013, at 2:01 PM, REDBUTTON_CTRL <jrorke@cogeco.ca> wrote:
Hi Richard, here are 2 diagrams to wire a radio to the URI with RLC/RC 210 wiring and also a crossover cable if you want to connect to the cobntroller.
If you want direct wiring follow both diagrams to make a single cable..
Essentially you want use the URI to radio diagram but reverse the TXA and RXA lines and PTT and COR lines and gender of the db 9 cable to mate with the RLC/RC 210 co9ntroller.
See attached schematics.
Regards,
Jon VA3RQ
On 10/20/2013 1:51 PM, Richard Szajkowski wrote: Going to try this again,
Any one have the pin to pin they are useing for a URI to Arcom / linkcomm controller
Richard Szajkowski
_______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users <HAM CONTROLLER CROSSOVER CABLE.pdf> <URI INTERFACE.pdf>