I think with a service monitor you will have a little more control. You'll be using the same master oscillator reference for both TX and RX adjustments Now, if you have an frequency accurate sig gen with 1KHz sine wave audio generator and you can set the deviation to 3KHz, then you'll probably be fine. On Wed, 2013-02-20 at 01:20 -0500, pete M wrote:
Why a service monitor? A deviation meter wont do it?
-----Original Message-----
From: Tim Sawyer Sent: 20 Feb 2013 03:59:07 GMT To: app_rpt-users@ohnosec.org list,Benjamin L. Naber Subject: Re: [App_rpt-users] [Bulk] App_rpt Install for Dummies
You know, that's so true. It's really important for you (or a friend) to have a service monitor and the knowledge to use it properly. App_rpt makes setting up a node so much easier and accurate than any of the other VoIP technologies, which is one of the reasons app_rpt sounds so good, but you still have to know what your are doing. My "App_rpt Install for Dummies" focused on the computer setup and assumes you're a radio wiz. -- Tim :wq
On Feb 19, 2013, at 5:28 PM, Benjamin L. Naber <benjamin@kb9lfz.com> wrote:
One must not forget to become a friendly ham and ask for training from someone or ham club that has one, on how to *properly* use a service monitor to tune their allstar node setups.
While there is an alternative way, I really don't recommend it if they are going to have a community of users.
~Benjamin, KB9LFZ
_______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users