Hi, Ive been struggling for weeks trying to use the dsp squelch. The sql and diode calibration routine seems to work like the book says as well as setting all the rx/tx levels. The problem is when I set the squelch pot which seems to do nothing at all. It all works as I believe it should when using ext COR from the radio. Repeat and echolink and offline functions all work. It seems odd(to me) that the sql pot setting always returns zero. Main and status displays are below, followed by voter.conf Any suggestions? Ross 1 - Serial # (1234) (which is MAC ADDR 00:04:A3:00:04:D2) 2 - VOTER Server Address (FQDN) (10.0.0.140) 3 - VOTER Server Port (667), 4 - Local Port (Override) (0) 5 - Client Password (xxxx), 6 - Host Password (xxxx) 7 - Tx Buffer Length (3000) 8 - GPS Data Protocol (0=NMEA, 1=TSIP) (0) 9 - GPS Serial Polarity (0=Non-Inverted, 1=Inverted) (0) 10 - GPS PPS Polarity (0=Non-Inverted, 1=Inverted, 2=NONE) (2) 11 - GPS Baud Rate (4800) 12 - External CTCSS (0=Ignore, 1=Non-Inverted, 2=Inverted) (2) 13 - COR Type (0=Normal, 1=IGNORE COR, 2=No Receiver) (1) 14 - Debug Level (0) 15 - Alt. VOTER Server Address (FQDN) () 16 - Alt. VOTER Server Port (Override) (0) 17 - DSP/BEW Mode NOT SUPPORTED 18 - "Duplex Mode 3" (0=DISABLED, 1-255 Hang Time) (1/10 secs) (0) 19 - Simulcast Launch Delay (0) (approx 200 ns, 5 = 1us, > 0 to ENA SC) 20 - Ext. CTCSS Input Threshold (850) (0-1023) 97 - RX Level, 98 - Status, 99 - Save Values to EEPROM i - IP Parameters menu, o - Offline Mode Parameters menu q - Disconnect Remote Console Session, r - reboot system, d - diagnostics Enter Selection (1-20,97-99,r,q,d) : ----98---- S/W Version: 1.46 03/04/2014 System Uptime: 15834.4 Secs IP Address: 10.0.0.134 Netmask: 255.255.255.0 Gateway: 10.0.0.1 Primary DNS: 10.0.0.1 Secondary DNS: 8.8.4.4 DHCP: 1 VOTER Server IP: 10.0.0.140 VOTER Server UDP Port: 667 OUR UDP Port: 667 GPS Lock: 0 Connected: 1 COR: 1 EXT CTCSS IN: 1 PTT: 0 RSSI: 255 Current Samples / Sec.: 0 Current Peak Audio Level: 58800 Squelch Noise Gain Value: 14, Diode Cal. Value: 43, SQL pot 0 Press The Any Key (Enter) To Continue ----voter.conf--- [general] port = 667 buflen = 500 password = xxxx [40526] 40526 = xxxx,nodeemp,transmit,mulaw