I discovered app_rpt does not like ctcssfrom=no. Why? (I'm using DIAL). What am I missing? Thanks, Bob kk6ecm 73 -----Original Message----- From: kk6ecm [mailto:kk6ecm@gmail.com] Sent: Sunday, May 22, 2016 10:37 AM To: 'app_rpt-users@ohnosec.org' Subject: RX Input Adjust Failed What could cause the Error: RX Input Adjust Failed? DONE tries=12, setting=1000, meas=58, sqnoise=13 ERROR: RX INPUT ADJUST FAILED. No RF input to the radio. I'm attempting to setup a substitute receiver for testing, but am experiencing difficulty setting it up, and not wanting to make a switch to simpleusb, thus making the minimum number of changes. The substitute receiver (Yaesu FT-1500M) is detecting CTCSS, with USB COR out, and I'm using the speaker output. (see below conf file) Any thoughts? Thanks, Bob kk6ecm 73 from usbradio_tune... hdwtype=0 rxboost=1 txboost=1 rxctcssrelax=1 txctcssdefault=107.2 rxctcssfreqs=107.2 txctcssfreqs=107.2 ;rxctcssoverride=0 ;carrierfrom=dsp carrierfrom=usb ;dsp ctcssfrom=no ;usbinvert rxdemod=speaker ;flat txprelim=no txlimonly=no txtoctype=notone txmixa=composite txmixb=no invertptt=0 duplex=1 rxondelay=0 rxnoisefiltype=0 eeprom=0