Thanks for replying! Yes, jumper P551 is set to flat audio. I am working OK using carrier access, just not able to implement CTCSS access. On 10/26/2015 10:29 PM, Steve Agee wrote:
Did you change or check jumper P551 on the logic board of the radio to ensure you are sending DISCRIMINATOR audio to the U.R.I. ? If the jumper is in the other position (speaker audio) then it won't work.
N5ZUA
On 10/26/2015 6:52 PM, Dave Newmyer wrote:
Hello,
I recently updated from Asterisk ACID to Asterisk DIAL due to hardware (CPU) problems. The install went well, and I am now able to use the Lenovo CPU that I had trouble with (Sept 7, 2015).
I was recently informed that it would be preferable if I were to use CTCSS access on my node instead of carrier access, and I have been attempting to do so, first by activating ctcss via dsp in the usbradio.conf file, then by reprogramming my Mot M120 radio for a channel with carrier access, or the alternate channel with ctcss access and adding a line from pin 8 of the radio accessory connector to pin 7 of the URI.
In Radio-Tune-Menu, choice 4 Auto-Detect Rx CTCSS Level Value passes, but if I try performing a DTMF command like *81, I get no reply from the node.
Any ideas as to what I should try next?
Thanks,
Dave N N0KM
--- This email has been checked for viruses by Avast antivirus software. https://www.avast.com/antivirus
_______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users
To unsubscribe from this list please visit http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users and scroll down to the bottom of the page. Enter your email address and press the "Unsubscribe or edit options button" You do not need a password to unsubscribe, you can do it via email confirmation. If you have trouble unsubscribing, please send a message to the list detailing the problem.
--- This email has been checked for viruses by Avast antivirus software. https://www.avast.com/antivirus