Hi folks, I have a unique problem I am hoping someone on the list can help me uncover where to look next. The situation is this: I have repeaters are 2 mountain tops. Mountain 1 and Mountain 2. On Mountain 1 are (2) repeaters, a VHF (repeater A) and UHF (Repeater B). On Mountain 2 is a VHF (Repeater C) and UHF (Repeater D). On mountain 1, there are also voted receivers for Repeaters C & D. There are DIAL boxes on both mountains. Repeaters A&B using DIAL on Mountain 1 (non-voting config, just basic repeater), and Repeaters C,D and both voters using DIAL box on Mountain 2 (microwave links between mountain 1 & 2). Everything has it's own RTCM (so there are 6 RTCMs in this situation). Everything is private (no public allstar nodes) Looking at allmon2 (running on each of the DIAL servers) I can see that there are NO links established and the RSSI bars respond to each of the voted receivers appropriately. I have checked each RTCM and DIAL box and verified that everything is logging in to where it is supposed to, and no where else. The problem I have is that when you transmit on Repeater A, the audio is being transmitted on both Repeaters A & C. If you transmit on repeater C, the audio is only retransmitted on Repeater C (as it should be). Looking at allmon, even during a transmission, there are NO links established. Verbose output on asterisk (asterisk -rvvvvvvvvv) shows no links established on either DIAL box. I can't figure out why DIAL on mountain 1 is sending the audio over to Mountain 2 DIAL (and only on the VHF set of repeaters even though the UHF set has an identical config). Any thoughts on where I might go looking would be much appreciated... I have been tearing my hair out on this one for a while! Happy to share any requested config. Thanks in advance for any thoughts/comments/insights/etc! james KI0KN