I stepped away from this last night. I was getting frustrated. What I'm trying to do. dial via DTMF from radio and route the call to the local PBX in my home. I already have a Trunk established between the PBX and the BBB Node. I can place calls directly to the node, TX & RX. When I initiate a call to the phone from my HT the only response I get back is a courtesy tone. I have tried all of these combinations. *6 6001 # *6 6001 6 6001 # 6 6001 There is an IAX2 trunk from the PBX to the BBB AllStar node running 1.2.1. I can place a call to the node from the phone. I can transmit & receive. on the BBB node : I setup my test phone extension 6001 in iax.cnf file on the node the dial command is different dial=iax/6001 [6001] deny=0.0.0.0/0.0.0.0 username=6001 secret=xxxx dtmfmode=rfc2833 canreinvite=no context=radio-control host=dynamic trustrpid=yes sendrpid=no type=peer nat=no port=5060 qualify=yes qualifyfreq=60 transport=udp encryption=no callgroup=RPT pickupgroup=ALL dial=IAX6001 permit=0.0.0.0/0.0.0.0 allow=ulaw,gsm,h263 ======= rpt.conf 6=autopatchup,noct=1,farenddisconnect=1,dialtime= 40000 ; Autopatch up ======= In extensions.conf the phone patch is the [RADIO] context [radio] exten => _5XXX,1,Dial(iax/${EXTEN},17); ; home phones exten => _6XXX,1,Dial(iax/${EXTEN},17); ; mesh phones