Corey, Put the following in the node stanza(s) you want to control in rpt.conf holdofftelem=1 telemdefault=2 This will report local connects and disconnects but will mute others after a short time period. So on a real busy channel when you do a local connect you might hear other connect/disconnects for a short period therafter but then they will stop. The time is not documented but you could find it in the source. I think it is around 30 seconds to a minute. 73 Doug WA3DSP http://www.crompton.com/hamradio Date: Fri, 29 Aug 2014 13:10:25 -0400 From: n3fe@repeater.net To: app_rpt-users@ohnosec.org Subject: [App_rpt-users] Telemetry question A while back someone posted this is an email but I can't find it... There was a setting in the rpt.conf file that would allow local telemetry only. Basically I want to hear all the local connects and disconnects but I do not wish to hear all the remote ones. I had this setup on my portable node, but have since wiped the system. It was the only system I did not have a backup off.. It was two different settings I had to use. Could someone please post those setting again. Corey N3FE _______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users To unsubscribe from this list please visit http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users and scroll down to the bottom of the page. Enter your email address and press the "Unsubscribe or edit options button" You do not need a password to unsubscribe, you can do it via email confirmation. If you have trouble unsubscribing, please send a message to the list detailing the problem.