Understand... That is what is on the drawing... The supply voltage is 9.5 VDC regulated. I need to measure it. Thanks, Bob kk6ecm Sent from iPad
On Jul 23, 2015, at 3:09 PM, Doug Crompton <doug@crompton.com> wrote:
OK but to answer you first question - yes you could probably go up to 15 or 16 volts but 13.8 or 12 or anything in between or less would be fine.
You aren't going to get an 8V P-P swing with 12V though. Is it 8V P-P or RMS? Why so high? That is unusual.
73 Doug WA3DSP http://www.crompton.com/hamradio
Subject: Re: [App_rpt-users] DMK URI/URIx 6dB 12 VDC range? From: kk6ecm@gmail.com Date: Thu, 23 Jul 2015 13:56:59 -0700 To: doug@crompton.com
Good idea. I'm working with an 8 V signal level requirement. If I can get away with a lesser voltage to drive my exciter, I'll use it.
Thanks, Bob kk6ecm
Sent from iPad
On Jul 23, 2015, at 11:00 AM, Doug Crompton <doug@crompton.com> wrote:
It also works quite nicely on 5V as long as you do not exceed the P-P limit of the Opamp at that voltage. I use it with 5V on a system that needs a little more output punch and it works and sounds fine. Wire the opamp power source pin over to the 5V pin on the DMK. Give it a try. If it works it avoids anything external.
73 Doug WA3DSP http://www.crompton.com/hamradio
From: kk6ecm@gmail.com Date: Thu, 23 Jul 2015 10:01:18 -0700 To: app_rpt-users@ohnosec.org Subject: [App_rpt-users] DMK URI/URIx 6dB 12 VDC range?
I'm wondering if the URI/URIx 6dB 12 VDC (pin 25) range will handle 13.8 (14?) VDC that powers my radio. What is the margin? Looks like the op amp will handle 15.5 VDC. Am I missing something?
Thanks, Bob kk6ecm
Sent from iPad
_______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users
To unsubscribe from this list please visit http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users and scroll down to the bottom of the page. Enter your email address and press the "Unsubscribe or edit options button" You do not need a password to unsubscribe, you can do it via email confirmation. If you have trouble unsubscribing, please send a message to the list detailing the problem.