Have a node setup (repeater) with usbradio.. Using mostly default setup. at the moment I have rx /repeater setup for carrier access (no ctcss) Been testing this and the far end nodes report that they get get repeater tones & hang time from me if I try to just 'monitor' them using the *2 monitor functionality.. *3 works as expected but when I try to use *2 I'm getting those unexpected results and the far end is experiencing some grief/confusion. Am I misunderstanding how this should work? Or are there any common gotchyas where you'd think you're just monitoring but it's doing more than that? Sorry this is a bit vague.. I probably need to bring up another note and test this and report step by step what's happening. Thanks Steve -- This message has been scanned for viruses and dangerous content by MailScanner, and is believed to be clean.