---------- Forwarded message ---------- From: "Shane Morris" <edgecomberts@gmail.com> Date: 18/02/2013 4:14 AM Subject: Re: [App_rpt-users] Avoid squelch noise after receiving a signal To: "Thomas Delmonego" <iw3amq@dnet.it> Do you mean the tone or the "tail"? The tone is a function of the software, although I am not versed enough to tell you how to control that. If you mean the tail (the carrier that clicks back after an "over") then thats actually a part of your repeater, and not set in the app_rpt software, as far as I'm aware, as most repeaters I've used, connected to the internet or not, have had a tail of varying degrees (imagine a three minute tail - ikes!). Its probably the best idea if you don't want any tail - which I'm not even sure if you could properly implement - that you use a tone to acknowledge the repeater has heard you. Otherwise, you'll never know if you're getting through. Of course, we use a short tone and tail to tell us we got in, and we can talk through our tail on the LOX board and Simoco repeater, however, another system I used, I wasn't able to talk through the (thankfully short) tail. Hope this helps! On 18/02/2013 3:53 AM, "Thomas Delmonego" <iw3amq@dnet.it> wrote:
Hi, it's possible to avoid the typical squelch noise after the reception of a valid signal from a repeater RX? Is there a specific setting, if yes in what file? Many thanks for help! 73! Thomas, IW3AMQ
_______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users