also seems that the parallel port support isn't included in simpleusb?
Can you confirm this? Might be really easy to get it. I'll certainly be wanting to do this. :-) I'm still getting free Pentium III 1U rack serves lately :-) Which are quite sexy looking and convenient to use for this. The used 1U Quad Xeons I purchase are going for about $850. hihi BTW- runing full duplex chan_usbradio on a Pentium-3 733MHz box I see 10%CPU continuous (RX) with spikes up to 25-30% during TX-RX-DTMF useage That's with Top runing at a 20 sample per second rate (which eats some CPU itself mind you. This seems to suggest that an 'ol Pentium-3 can cut it for this app. Somebody please beat me with a baseball bat if I'm wrong!!
I played around with this a little bit today... Seems like you have to use: rxchannel = Simpleusb/usb rather than: rxchannel = SimpleUSB/usb.
I could be wrong, but it also seems that the parallel port support isn't included in simpleusb? I did observe a substantial decrease in processor usage.
Too bad it's not as simple as DSP=0 or DSP=1 to enable/disable the DSP techniques in chan_usb... hi hi
73,
Kyle K0KN --- Original Message ---I think all you have to do is this.....
rpt.conf: (snip)
[2532] ; Change this to your assigned node number
rxchannel = SimpleUSB/usb ; Rx audio/signalling channel
simpleusb.conf: (entire file)
; ; SimpleUSB configuration ;
-- This message has been scanned for viruses and dangerous content by MailScanner, and is believed to be clean.
_______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users
Michigan Broadband Systems Inc. "Always Connected" (734)527-7150 Steve's cellphone: (734)904-1811 -- This message has been scanned for viruses and dangerous content by MailScanner, and is believed to be clean.