And I can confirm, that change did it. I compiled the new source and my test limey box indeed responds to cos on parallel port pins. Thanks!!!!! GeorgeC W2DB 2360 ----- Original Message ----- From: Jim Duuuude To: george@dyb.com ; jd0@broadsci.com ; app_rpt mailing list Sent: Tuesday, August 30, 2011 9:55 PM Subject: Re: [App_rpt-users] Parallel port I/O withchan_simpleusb/usbradiounder Limey Linux that will be correct *after* I update them into SVN. You can follow the upgrade from SVN procedure in the 'support' section of the allstarlink.org website. JIM ------------------------------------------------------------------------------ From: george@dyb.com To: telesistant@hotmail.com; jd0@broadsci.com; app_rpt-users@ohnosec.org Subject: Re: [App_rpt-users] Parallel port I/O withchan_simpleusb/usbradiounder Limey Linux Date: Tue, 30 Aug 2011 21:37:06 -0500 So...(I'm a hacker, not a programmer)...as I understand this, if I get the new sources into my limey box I can compile them with the new source? I have a slackware linux laptop where I made my own limey one time, and it worked fine (on a D201 board before you folkis combined that with the D945 stuff) The ACID distro I downloaded on Saturday has to be right, it works like a champ on the printer port. Also, in the docs it does not mention that pin 11 is available, and I peeked at the source and found that it was, and it did work. The controller I married it to has COS on pin 11, I didn't feel like soldering. OK, Jim, thanks for the info/insight. GeorgeC