I ran an experiment this weekend building a new server, and have some questions. I could not get the computer BIOS to boot with a basic network interface, so began with CentOS 5.10 DVD, which installs the drivers. (The ACID CD could not see the network when attempting to download phase1.sh.) I then used the scripts from the ACID CD to install Asterisk/app_rpt. I manually downloaded and phase1.sh (using parts of ks.cfg on the command line), and made the script executable, then went from there to complete the "ACID" install. It worked great as a method to get past the lack of initial network driver, and the node is registered on Allstarlink.org. I have a couple of issues. 1) The new boot gives me a fail for ip6table load. The CentOS 5.10 did not have this error on reboot after the load. It only occurs after "completing the load" with the ACID scripts. How is this used in ACID, and is it necessary? Is it used for security setup? 2) The build has the same issue with not being able to comm correctly with the URI as I've had with other computers where the chipset and build are not compatible. I did not check the compatibility with the CentOS 5.10 build before the "ACID" install. I use the uridiag program to determine compatibility (asterisk off). I'm thinking of attempting this with CentOS 6.5, but suspect the overwrite from executing the ACID scripts, which download Asterisk updates, with not be compatible. I'm wondering if I can go directly from CentOS 5.10, or 6.5 using the astinstall.sh script Any suggestions? Still a Linux newbie sorting out his options. Thanks, r/Bob kk6ecm