Sorry, didn't notice that was off list..... Copied below. -- Robert A. Poff Loganville, PA S/V Loon 1983 Hunter 34 Havre de Grace, MD. WB3AWJ - Allstar 27784 Powered by Linux -------- Forwarded Message -------- From: Tim Sawyer <tim.sawyer@me.com> To: Robert A. Poff WB3AWJ <wb3awj@comcast.net> Subject: Re: [App_rpt-users] Frequency Agile Remote - Continued Date: Fri, 26 Jul 2013 22:31:53 -0700 Here's my Xcat config... if it helps any. [2535] ; Change this to your assigned node number rxchannel = Simpleusb/usb ; Rx audio/signalling channel remote = xcat civaddr = 32 functions = functions-remote lconn = PP3=1 ldisc = PP3=0 memory = memory ; Section to hold memory entries (optional) ; remote=ft897 for Yaesu FT-897 or ; remote=rbi for Doug Hall RBI1 ; remote=kenwood for Kenwood mobiles such as the TMG707A ; remote=ic706 for the Icom IC-706 ioport = /dev/ttyS0 ; Specify port for serial port (optional) iospeed = 19200 dusbabek = yes ;iobase = 0x378 ; Specify IO port for parallel port (optional) authlevel = 2 ; Remote base authentication level ;; authlevel = 0 : Anyone can use it ;; authlevel = 1 : Requires log in, Waits for Tx key to ask for it ;; authlevel = 2 : Requires log in, asks for it automously ;mars = 0 ; set=1 for IC-706 w/MARS mods (optional) remote_inact_timeout=1800 ; Inactivity timer for remote base nodes only (set to 0 to disable). remote_timeout=5400 ; Session time out for remote base. (set to 0 to disable) ;remote_timeout=120 ; Session time out for remote base. (set to 0 to disable) ;remote_timeout_warning=30 -- Tim :wq On Jul 26, 2013, at 9:21 PM, Robert A. Poff WB3AWJ <wb3awj@comcast.net> wrote:
Still can't set the frequency on an XCAT.
I've done a complete clean install.
By running Asterisk in the foreground and turning up the debug levels, I see the CIV command being sent to the XCAT is
FE FE 20 E0 08 01 FD
Which if I'm right is trying to retrieve memory #1 from the radio. Not write to the VFO (function 05 instead of 08). In rpt.conf I have the remote defined as xcat (remote = xcat).
So what gives?
Again, this was working before I updated from a version of app_rpt from about a year ago, to current.
Robert A. Poff Loganville, PA.
"Lieutenant, target the offending power boat and launch photon torpedoes"
_______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users