A file would be dependent on your particulars. But, It's just a node as any other, define your cor/ptt/pl logic & audio methods, and if is a freq agile remote, you may need to define port for tuning. See the wiki (i think it's in there) but some tune via serial and a DH-1 and some other though a parallel port definition. And define what kind of radio remote it is so it's tuning the right data instructions on that port. A parallel port definition in rpt.conf iobase=0x378 ; Parallel port address or civaddr=72 ;(for ic-706) Radio: remote=ic706 remote=rbi ; (doug hall rbi-1) and last you need to specify that the node number is a remote base in rpt.conf node descriptions, with a 'Y' 1999 = radio@127.0.0.1:4569/1999,Y But it might help some if you state what kind of remote base you wish to set-up. It's not all the same. hope this helped. ...mike/kb8jnm On 9/6/2018 12:35 AM, George Csahanin wrote:
Folks, I had a remote working back around 2010 using app_rpt. B ut I cannot find my documentation. I'm trying to lash it up again. But hit a brick wall on setting it up. Anybody have any config info that pertains specifically to remote.
I've googled it but it leads to pretty incomplete info on this...
GeorgeC W2DB
nodes 2360, 2428, 28599
--- This email has been checked for viruses by AVG. https://www.avg.com
_______________________________________________ App_rpt-users mailing list App_rpt-users@lists.allstarlink.org http://lists.allstarlink.org/cgi-bin/mailman/listinfo/app_rpt-users
To unsubscribe from this list please visit http://lists.allstarlink.org/cgi-bin/mailman/listinfo/app_rpt-users and scroll down to the bottom of the page. Enter your email address and press the "Unsubscribe or edit options button" You do not need a password to unsubscribe, you can do it via email confirmation. If you have trouble unsubscribing, please send a message to the list detailing the problem.