Sorry for the l-o-n-g delay... found this in my 'Drafts' folder. Maybe my phone rang, or the door-bell rang - don't know why I didn't finish it, but it's pertinent to discussion of app_rpt -Geoff On 01/22/2014 11:13 AM, Tim Sawyer wrote: Good point. And the telemetry stanza comments say: ; Telemetry entries can be shared across all repeaters, or defined for each repeater. So I'd say you CANNOT have separate morse stanzas. Well... kinda... Technically, yes - only one morse stanza can be defined, but different ID strings can be entered for each node. What's funny is, (it's really comical) my node 29657 (2m simplex node) is the *3rd* node defined in rpt.conf. If I key up the simplex node *first*, upon an asterisk re-start, then the morse stanza for 29657 is used through out rpt.conf. Meaning [morse29655] speed=20 ; Approximate speed in WPM frequency=500 ; Morse Telemetry Frequency amplitude=2048 ; Morse Telemetry Amplitude idfrequency=1000 ; Morse ID Frequency idamplitude=2048 ; Morse ID Amplitude [morse29657] speed=20 ; Approximate speed in WPM frequency=1000 ; Morse Telemetry Frequency amplitude=2048 ; Morse Telemetry Amplitude idfrequency=500 ; Morse ID Frequency idamplitude=2048 ; Morse ID Amplitude If I key up the 2m simplex node, the freqency of the ID is low, and enjoyable. If the repeater is keyed first, there's a 1k tone used for the ID. (I'm old school - not that 'up' on voice ID's) CW doesn't bother the on-going conversation like a voice-id does.