Running 3 nodes on the DIAL release is likely not going to work. You may want to try Doug and David's release which uses a different channel driver. I've never heard anyone having luck running more then 2 nodes on the Raspberry Pi release in full DSP, but I have heard of success with the other. Kevin On 7/10/2016 10:57 AM, Ramesh Dhami wrote:
Hi Kevin and Steve:
First, the Pi is running 3 full duplex nodes using DSP!
I am seeing some audio issues too, which may be a sign of pushing the limits of the Pi.
Secondly, I am using home brew fobs (StarTech CM108 conversions).
I have two 220 repeaters in my shack, I will test on the second repeater, using a different fob, which may help to pin point the issue.
I must confess that I have 3 different rev levels for my fob conversions, two of my fobs do not have a label on them, so maybe I am using one of my early fobs, where I just had one audio output!
I will test and let you know!
Cheers,
Ramesh.
Sent from my iPhone
On Jul 10, 2016, at 10:30 AM, Kevin Custer <kuggie@kuggie.com> wrote:
Yes - I have several of these running this way.
What are you using for your "fob".
On 7/10/2016 10:04 AM, Ramesh Dhami wrote: Hi All:
I am using the DIAL Image on a PRi 2; I would like to use the "A" and "B" audio outputs from my fob (A for voice and B for PL), so that I can inject them into separate points on my exciter.
I was able to get 2 'discrete' audio outputs when running ACID on a PC. This doesn't seem to be working with the Pi / DIAL. Is anyone running this configuration on a Pi?