Have it all installed on a Pi-Zero and linux boots fine, wifi connects fine, asterisk shows "segmentation fault" and in the log files: /Apr 23 03:24:20 repeater systemd[1]: asterisk.service: Service hold-off time over, scheduling restart.// //Apr 23 03:24:20 repeater systemd[1]: Stopped Asterisk PBX and telephony daemon.// //Apr 23 03:24:20 repeater systemd[1]: Started Asterisk PBX and telephony daemon.// //Apr 23 03:24:20 repeater systemd[1]: asterisk.service: Main process exited, code=killed, status=11/SEGV// //Apr 23 03:24:20 repeater systemd[1]: asterisk.service: Control process exited, code=killed status=11// //Apr 23 03:24:20 repeater systemd[1]: asterisk.service: Unit entered failed state.// //Apr 23 03:24:20 repeater systemd[1]: asterisk.service: Failed with result 'signal'./ This repeats many times. Really not sure where to start looking. I used ldd to see if libraries were ok, and all was fine: /repeater@repeater:/var/log $ ldd /usr/sbin/asterisk// // /usr/lib/arm-linux-gnueabihf/libarmmem.so (0xb6f5b000)// // libdl.so.2 => /lib/arm-linux-gnueabihf/libdl.so.2 (0xb6f48000)// // libpthread.so.0 => /lib/arm-linux-gnueabihf/libpthread.so.0 (0xb6f1f000)// // libtinfo.so.5 => /lib/arm-linux-gnueabihf/libtinfo.so.5 (0xb6ef0000)// // libm.so.6 => /lib/arm-linux-gnueabihf/libm.so.6 (0xb6e71000)// // libresolv.so.2 => /lib/arm-linux-gnueabihf/libresolv.so.2 (0xb6e4c000)// // libc.so.6 => /lib/arm-linux-gnueabihf/libc.so.6 (0xb6d0d000)// // /lib/ld-linux-armhf.so.3 (0xb6f71000)// //repeater@repeater:/var/log $ / Anybody have any suggestions? GeorgeC W2DB 2360, 28599