Hi Michel, Ok set duplex = 0 in the Rpt.conf And set your hangtime = 1 (change it from 1000). That should get you simplex node working. Also there will be no telemetry but you will hear connect /disconnect messages. If there is no statement in Rpt.conf for duplex, it operates in full duplex by default. Hope this helps. Jon VA3RQ On 7/4/2011 6:16 AM, Michael Carey wrote:
Hi Everybody,
I'm busy finalising my AllStarLink node 27871 . It's going to be a simplex (for now) node with the future potential to be linked to my local 70cm repeater.
I am finding one little problem that I can't seem to solve. I have set duplex in usbradio.conf to zero (0) and duplex in rpt.conf to one (1), but as soon as my node radio receives a transmission, it keys up straight away... over the incoming transmission, almost as if it is still configured for duplex mode. This makes it real hard to enter any DTMF codes. (-: Where should be I looking to solve this?
I am handling CTCSS (both TX and RX) in the node radio itself (I am using a Simoco SRM9000 VHF commercial radio). I have a low going logic level that has been tied to the radios "valid signal" flag which is set to CTCSS 107.2Hz, this is fed to the COS input on my URI. The audio output from the radio is squelched, highpass filtered and de-emphasised.
I have set carrierfrom=usb and ctcssfrom=no, I think this then disables CTCSS decoding within the computer. Does this also disable transmitting CTCSS? I have set txmixa=voice which I presume also stops CTCSS from being output from the URI.
I look forward to hearing from you all... via the email list and on air too!
Michael VK5ZEA
_______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users