If things are working well using DSP, then why would you want to change them up, unless you want to use a slower computer that does not have the horsepower to do DSP? In /etc/asterisk/usbradio.conf change the line that currently reads: carrierfrom=dsp to read carrierfrom=usb or carrierfrom=usbinvert The "usb" setting is for COS active HIGH (+5 VDC) and "usbinvert" is for active LOW, which would pull the line to ground when active. In the LOW situation, use a volt meter to make sure there is voltage present to be able to be pulled down. You will also need to change the line that reads: ctcssfrom=dsp to ctcssfrom=usb if you have a separate line for CTCSS detection. Some radios, like the GM300, let you put both the cos AND ctcss on the same line. In that case, set ctcssfrom=no to ignore it. N5ZUA On 3/7/2015 10:11 AM, Skyler F wrote:
How can I trigger the Allstar receiver when it gets a voltage from COS or switch 3 on the fob?
Does it automatically trigger when a voltage is there?
I added 5v to the COR URIx and did not get any trigger and I also tried closing SW3 on the home brew fob. Am I doing something wrong?
I will be getting a COS out on my radio and want to use The CTCSS on the radio instead of in AllStar.
Thanks Skyler
-- Skyler Fennell amsatnet.info <http://amsatnet.info> KDØWHB electricity440@gmail.com <mailto:electricity440@gmail.com>
_______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users
To unsubscribe from this list please visit http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users and scroll down to the bottom of the page. Enter your email address and press the "Unsubscribe or edit options button" You do not need a password to unsubscribe, you can do it via email confirmation. If you have trouble unsubscribing, please send a message to the list detailing the problem.