Nope, the idea of setting duplex=1 doesn't work. With duplex=1, the radio TX is ALWAYS briefly keyed immediately after the COS signal from RX drops. I tried setting hangtime=0, etc. This causes my HF rig to go into an infinite key/unkey loop due to the nature of its voice squelch circuit. I guess I can just make an audio file of silence for the ID and leave duplex=0..... 73, David KB4FXC On Thu, 9 Oct 2008, David McGough wrote:
...I just found something else of interest. When I copied my repeater stanza to my original remote base nodes, I left the original CW ID audio file specified as the object of the idrecording variable. On the asterisk console, I'm seeing the standard "Playing 'kb4fxc.4.ulaw'" message that I get for the repeater node on all the nodes now. And, if the remote base (now a standard node) is keyed, the ID is transmitted! If unkeyed, it's not transmitted. Note that duplex=0 for these nodes. I guess I can make a audio file of "silence" for these nodes, etc. Or, perhaps, make a correct ID file and set duplex=1???
73, David KB4FXC
On Thu, 9 Oct 2008, Eric Fort wrote:
on a side note could the frequency agility be done through the dialplan and agi?
Eric
On Thu, Oct 9, 2008 at 12:57 PM, David McGough <kb4fxc@inttek.net> wrote:
Hi Steve,
Okay, I reconfigured both remote bases as standard nodes--I just copied the context used for my repeater node and set duplex=0. This works properly with VOX mode, manual keying/unkeying, etc., just like with the repeater node....No issues.
And, okay about the link status--I just thought the segfault was interesting.
So, other than loss of frequency agility, can you think of any other "show stoppers" that I might hit by retiring remote base mode entirely and just using standard mode for everything??
73, David KB4FXC
On Thu, 9 Oct 2008 hwstar@rodgers.sdcoxmail.com wrote:
See below
Steve WA6ZFT
<* snip *>
First off: Link status doesn't make sense on a remote base! Remote bases are for exclusive use by one user at a time!
Key-unkey flakiness. Two things to check:
1. What happens when you configure the HF and VHF radios as a standard
node (with duplex=0)? The remote base code is separate from the standard node code, and there could be a keying bug could be in the remote base code.
2. Please confirm the phone key/unkey is not flakey on your standard
node.This key/unkey issue could be a SIP configuration issue.
_______________________________________________ App_rpt mailing list App_rpt@lists.illiana.net http://lists.illiana.net/mailman/listinfo/app_rpt
_______________________________________________ App_rpt mailing list App_rpt@lists.illiana.net http://lists.illiana.net/mailman/listinfo/app_rpt