29 May
2012
29 May
'12
1:16 p.m.
Quick question on usabilityIf you don't already have it set this way, try changing the command to: 80 = status,11 N5ZUA ----- Original Message ----- From: Alan Adamson To: App_rpt-users@ohnosec.org Sent: Tuesday, May 29, 2012 12:06 PM Subject: [App_rpt-users] Quick question on usability I don't want to be a bad operator at the moment. As I go about checking bandwidth and jitter, etc on my setup. I'd like to connect to an active Hub, but just in eavesdrop mode. But I've noticed that if I connect with the *2 command, that if I inadvertently then do a *80, that the ID goes out on the link that was connected with the *2. Is this true anytime my node decides to ID? Alan