Lu I am no expert but I do use the remote command often. First you need to be connected to the node that you want to control. Then dial *xxxxxx (the node you want to control). You will then hear a very overdriven audio file that says remote command. From that point on you are controlling that node you can (connect,disconnect, etc). To exit remote comand mode hit the # sign. Hope this helps Neal NG8Y Sent from my iPhone On Jul 27, 2011, at 8:52 PM, "Lu Vencl" <vencl@att.net> wrote:
Ok,
I know this is a newbie question, but I searched everywhere I know and I can’t find an example nor figure this out..
I need to understand the proper command structure or procedure of *4 remote command.
Example, I want to issue a command to one of my nodes from another node. How do I do this?
I tried the following example from my node 27870
KA4EPS-R-Margate*CLI> rpt fun 27870 *427869*81#
I thought that this command would allow me to announce the time on node 27869 while entering this on the 27870 node..
Is this not possible?
Another example, let’s say I want 27869 to connect to 27875 would I want to dial over the air on (node 27870) *427869*327875# ?
Thanks again for your help.. I am just not getting anywhere with it.
Lu, KA4EPS
_______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users