As I am reading this thread about the RC210 and the software a question come to mind.. Is a controler mandatory to use the app_rpt software?? your getting me confuse.. -----Original Message----- From: Doug Hutchison Sent: Friday, May 27, 2011 5:13 PM To: App_rpt-users@ohnosec.org Subject: Re: [App_rpt-users] Allstar Node and RC210 Issues Have you adjusted the TX audio pot on the 210? Port 2 must be simplex (non repeat) as Matt said. D On 27/05/2011 21:59:34, Charles Rader (kc5dgc@centurytel.net) wrote:
Monty,
Thank you. The conf file you sent me was a big help. I wished mine conf files was commented like the one you had. That explains a lot. I made the changes you said to make in the rpt.conf. It helped increase my audio and it sounds much better for some reason now. I am still having issues with the link UHF repeater though. Here is my setup: RC210 Port 1 UHF Repeater, Port 2 URI (allstar)
URI to RC210 Port2 Pin 1 (PTT) to Pin 7 (RX COS) Pin 8 (COR DET) to Pin 3 (TX PTT) Pin 13 (GND) to Pin 9 (GND) Pin 21 (MIC IN AC) to Pin 4 (TX AUDIO) Pin 22 (LEFT OUT AC) to Pin 5 (AUDIO INPUT)
RC210 Port 1 and Port 2 Linked Port 2 setup- Hang Timer=0; Transmitter Enabled; Receiver Enabled; Repeater Mode; DTMF Enabled; Monitor Mix; Access Mode= Carrier
I can Link my Allstar node to an active Allstar Mode and I have great audio repeater on the UHF Repeater. But when I key up to transmit on my UHF repeater I am getting PTT Lights on Port 2 on the controller but I am not getting a keyup or audio on the Allstar node either locally (via iaXrpt) or through Webtransciever. Also I can’t connect or send any commands via the UHF port to Allstar.
Any ideas? I was told that I shouldn’t program port 2 on the RC210 as Repeater mode?
Thanks for all your time and help.
From: Monty Sent: Friday, May 27, 2011 2:12 PM To: Charles Rader Subject: Re: [App_rpt-users] Allstar Node and RC210 Issues
Hi Charles, I have interfaced Allstar to my RC-210. I had a couple of problems. One was my wiring, everything is backwards. PTT on the arcom goes to COR on URI, Audio out to audio in, etc. So i would check that.. Also if you haven't done any config on your allstar node, that might be
App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users