If you transferred files over from and Acid install did you enable USBRadio and disable Simplusb in module .conf? And if that was taken care of, do you have your ctcss tones commented out but Ctcss from set to dsp in USB Radio.conf? What is your squelch setting at?? VA3RQ On 10/8/2016 9:22 AM, Steve Zingman wrote:
Did you run radio-tune-menu? disable ctcss decode and try as carrier only.
On 10/08/2016 08:39 AM, Steve Mahler wrote:
Good Morning! I swapped PCs yesterday on my repeater, and now a big problem. Please, I need some help from DIAL Wizards.
The critical problem is the RX audio does not get transmitted, but all other audio paths seem to work. Additional information ...
1. iaxRpt connects normally, and plays at normal level audio from the RX, also transmitting from iaxRpt goes to the TX at a normal level
2. Links to other repeaters, no problem to hear distant audio, but RX audio is not sent to the distant repeater (but goes out on other IAX links)
3. Playing audio files from app-rpt are heard on the transmitter at normal levels.
Configuration ...
i) RX is discriminator audio to URI, no COS/COR/PL signaling
ii) TX is voice audio and a separate PL audio mixed in the radio.
Process ...
A. I took a second PC and loaded DIAL.
B. I updated files in /etc/asterisk
C. usbradio_tune_usb42316.conf and patched in the new devstr, but left all the levels the same
D. usbradio_tune_usb42316.conf ... I noted the new "fever=1" (and have tried it at values 0 and 1) but have found no documentation for fever.
E. I swapped the new PC for the old PC ... same URI, Ethernet, etc. ... It worked, but I missed the RX to TX loss problem during the install.
F. Note, when you unkey the courtesy tone, tail messages, etc. play
Thinking ...
a. It is like the DSP PL is not working but I am using the same config I did under ACID
b. Setting rxctcssoverride = 1 does not change the operation.
ANY information about necessary changes between ACID and DIAL, or just proper DIAL operation appreciated. I would hate to have to reinstall the ACID based PC.
...STeve - KF5VH
_______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users
To unsubscribe from this list please visit http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users and scroll down to the bottom of the page. Enter your email address and press the "Unsubscribe or edit options button" You do not need a password to unsubscribe, you can do it via email confirmation. If you have trouble unsubscribing, please send a message to the list detailing the problem.