Hello all. I have 2 Nodes here an RTCM on node 28467 and a Beagle xM/LOX combo on node 29701 The RTCM works real well, no problems at all, but, the Beagle xM on the other hand has a one little issue I can’t seem to fix, can’t been seen in the database. Reading the mail on this list the past few weeks and this same issue has already been raised, I see that I cannot have 2 different Nodes with the same port ( 4569 ) running on the same IP, they have to have unique port numbers. To that end I have left the RTCM on port 4569 but I have moved the Beagle xM to port 4568. Having done that to the Beagle xM I went in to the iax.conf and changed the bindport there, then I went in to allstarlink.org and changed the port number there too and submitted the changes. The Beagle xM now works fairly well, I can make outgoing calls AND it can receive incoming calls also but the Beagle xM ( node 29701 ) is not seen to everyone, no longer in the database. The router I use here at home is a Netgear DGND3700 and it doesn’t seem to allow the Beagle to be registered in the database, but when I test the Beagle on another router I have, a TP link 3G the Beagle is seen by everyone and it looks like it is in the database. I believe there are a few routers that do give a bit of trouble, and the Admins can do something to help get Nodes registered so I think I am in need of their help at this point, if no-one else has any other suggestions. Thanks guys. Ron. VK3ANT Melbourne.