Hello, I have been attempting to get my simplex node back up and running after being off of the air for a couple of years. The ULI device and radio are the same, but the computer, installation software, ect. are all different. I am using a new install from an acid-centos.iso I downloaded a couple of days ago. At post-install, I get the following: mpg123:no process killed. Asterisk ended with exit status 1 Asterisk died with code 1 Automatically restarting Asterisk This repeats over and over. I checked the archives, and found a series of postings from someone who had a similar problem some time back. In reading the log file /var/log/asterisk/messages the errors refer to a problem with Zaptel. One of the suggestions was to update Asterisk from SVN, then update Zaptel. After doing this, Asterisk started, and I was able to perform system info and time DTMF commands to my node. Later, I tried resetting the computer and after restarting it, I am back to the mpg123:no process killed. Asterisk ended with exit status 1 Asterisk died with code 1 Automatically restarting Asterisk Errors over and over and over again. I am thinking that possibly my config files on the AllStar.org website might have an issue, but on one of my re-installs of the software from the cd, I chose not to download the remote configs. Anyway, I am not sure what to try next. 73, Dave N N0KM --- This email has been checked for viruses by Avast antivirus software. https://www.avast.com/antivirus