All, I have a 2002 vintage, VIA EPIA Mini-ITX box (C3 Eden 800Mhz processor). It has 512 MB RAM, and a 60Gig hard drive. The ACID / CentOS install CD, will not complete the boot process, it goes into a loop. At the point shown in this picture: http://www.qsl.net/k4bry/mini-itx_boot-fail.jpg , the screen goes dark, and the box reboots into the CD again. The CD is good, it was used on my first install with no problems. I have manipulated the BIOS settings for several hours, with no change in the result. It may be caused by a lack of enough RAM, but I Don't know. If there is documentation on the minimum requirements for an ACID install, I can't find it. If I try to find RAM to take it to the 1 Gig maximum, it is likely to cost more than this old Motherboard is worth. After no progress with this, to see if it was hardware failure, I installed the Kubuntu-10.04-Alternate-i386 version of Ubuntu, GUI and all, without a hitch. It runs very slowy, which is to be expected, but it does run. Does anyone see an obvious problem, or have any idea what I should try next? I have a second box with the same Motherboard, It would be nice and cheap, if I could get them both working. Thanks for any help. Joe Bryant K4BRY