How about rpt cmd 2211 cop 61 GPIO4=1 (since that's what would go in the line for a DTMF function) JIM From: yokshs@sbcglobal.net To: app_rpt-users@ohnosec.org Date: Tue, 25 Jan 2011 13:57:28 -0600 Subject: [App_rpt-users] manually issue COP command? Hi Tim (and the list), Thanks for the reply.. I have these entries in usbradio.conf: pp3 = ptt pp11 = cor ; pp10 = in ; in, cor or ctcss ; pp12 = in ; pins 10,12,13,15 are for DTMF ; pp13 = in ; pp15 = in pp4=out0 ; pins 4,5,6 are AUX 1,2,3, default off pp5=out0 pp6=out0 My PTT and COS via the parallel port work perfectly, but so far, the only success I've had controlling other pins has been by assigning them to PTT. For example, as a test I set: pp3 = ptt pp4 = ptt pp5 = ptt pp6 = ptt This keys all 4 outputs any time PTT is called for. I just wanted to make sure that app_rpt could control those pins.. Besides that, I've had no success trying to use COP 61 or 62 to control my pp4,5,6 I've tried the syntax you suggested: rpt cmd 2211 cop 61 pp4=1 I've also tried every other thing I could think of, including: rpt cmd 2211 cop 61 pp4=1,0 rpt cmd 2211 cop 61 pp4=1.0,0 rpt cmd 2211 cop 62 pp4=32767 73. Kyle K0KN --- Original Message ---I've not played with this but my guess is... You in usbradio.conf you should put this in the [usb] stanza: pp2=out0 ; set parallel port pin 2 to low output. Then this should change it to high: CLI>rpt cmd 2211 cop 61 pp2=1 Jim or others please jump in here if I have it wrong. -- Tim :wq _______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users