Hi Jeff, I haven't played around with this lately, but seem to remember that any nodes connected together will decode the same MDC and act on it, if set up to do so. If you look in /tmp/mdc.log, you'll see the timestamp, node number and ID listed that the command came from. I would say try a simple macro like ilink,5 (what's connected) and see who responds. Tony --- On Tue, 9/18/12, Jeffrey S. Carrier <jeff.carrier@rmsmsecurity.com> wrote: From: Jeffrey S. Carrier <jeff.carrier@rmsmsecurity.com> Subject: [App_rpt-users] Remote command? To: app_rpt-users@ohnosec.org Date: Tuesday, September 18, 2012, 11:14 AM Quick question, I’m playing with MDC1200 control due to all of the recent posts. I have that part working but here is my issue. I have 4 nodes, 3 of them are connected to radios and one of them is a hub node. The hub node is connected to the internet and is the connection point to the allstar and echolink network. The 3 nodes connected to the radios are on private wireless LAN. I’d “like” to be able to send a command on one of the RF nodes via either MDC1200 or DTMF to say disable incoming connections but that command has to be passed to the “hub” node. Is there a way to properly format a macro to accomplish this or am I stuck with doing *4XXXXX then sending the command? Thanks in advance 73 de K0JSC -----Inline Attachment Follows----- _______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users