2009/11/3 Ramesh Dhami (VA3UV) <Ramesh@va3uv.com>
Hi Matt;
Not sure why you are using duplex=3 on a repeater node.... have you tried duplex=2? (this is the correct setting for a repeater node)...
From the ACID sysadmin manual...
duplex=2: Full Duplex with telemetry tones and hang time. This mode is preferred when interfacing a repeater.
duplex=1 is half duplex, so yes, your COS will be ignored.
duplex=3 is full duplex, but no repeated audio.
Also what is your duplex setting in usbradio.conf? - you want to set that to duplex=1 so that you can issue dtmf codes while the node is transmitting.
Let me know how you make out...
Cheers,
Ramesh.
Hi there Ramesh and thanks for the reply. Hope all is well with you? I'm using duplex=3 because if I use duplex=2 I get two sources of repeated audio: - One via the RC210 and its RAD board ( I know you're familiar with the Arcom controllers ) - One via app_rpt This causes an echo in the repeated audio due to the different delays. So, I used duplex=3 which stops the app_rpt repeated audio. It all used to work OK.... I will check the usbradio.conf duplex setting maybe thats my problem..... Thanks for the info Ramesh, I'll let you know how it goes.... Cheers and hope to chat again soon, when is the best time to catch you on your node? 73 Matt