Since we have a group of new users around.I Just wanted to share a few little helpers I picked up and some working configs to compare with. Check out the source of app_rpt.c lots of help at the top, most if not all of the commands are documented there. It helped me a lot when I was first getting started. The included tarball has my complete working config files - a couple passwords and pincodes, my crontab, some custom scripts, and the weather scripts I modified from IRLP. W0ANM and Randy KC6HUR wrote them. I hacked them up to work with asterisk. and the Cepstral voice William. I also used William to replace a bunch of asterisk words to keep the repeater audio consistent. No offense to Jim, Steve, and Allison. (Speaking of Allison, I met her at Astricon one year, Freaked me out, I didn't know what she looked like, the door to the elevator opened, this chick at the door said something like "hello, going down?" I started looking around at the speakers in the elevator trying to figure out how someone got Allison to do voice over work for the elevator. then it hit me.. SHE was Allison....LOL) I also included some scripts I use for changing how the repeater functions. they change hang times, Courtesy tones, ID's, and gets the node connected up for weather events. I also have a restore to normal function. It does copy around the /etc/asterisk/rpt.conf so be careful in playing with them. backups are important. As far as my hardware: I am using de-emphasized audio (speaker) and have a COR signal from the receiver going to the FOB. In addition to the caps, I also used 1:1 transformers on the RX/TX audio lines to kill any ground loops. I also put in some ferrite beads on the audio lines, made sure everything was properly grounded, including the usb connector on the fob, that solved a lot of ills with ground loops(hum) on my end. I did change most of the values to make things suit the audio levels I needed. The original fob design was designed for Motorla or other Radios with very hot discriminator audio. My GE wasn't quite that hot, and the ICOM I used for a while was even lower. So feel free to play with them or just put in a pot and trim around at will. My current receiver is a Motorola Astro Saber running in Dual mode IMBE NAC 294/Analog PL 97.4. I took the audio from the speaker mic output through the 1:1, I also took one side of the audio line w/ a pull 2k pull down resistor to the COR pin. works like a charm. A lot of Motorola radios only power on the audio amp when there is proper PL/NAC. both sides of the amp have a floating DC bias that changes when the amp powers on, floating when off, +4.7 when on. I little trick I got from Jim WB6NIL... My previous receiver was an old Uniden that I tapped raw Discriminator and fed the fob via the 1:1 transformer. That also worked pretty good with the DSP mode. Until the person I got the radio from played Indian giver. The transmitter is nothing fancy.. just an old Kenwood G707 mobile being fed from the packet jack (ps2 type) on the back. I do have an Industrial mega CFM fan blowing across the back of the transmitter to keep it cool. So far its doing just fine. My system is not very heavy in traffic. Eventually I want to replace it with something more robust like a spectra or X9000 syntor. If I can get my hands on one cheap. Hope they are useful to some of you. -- Don Russell, CBRE W9DRR ARRL OES, Technical Specialist Winnebago County AEC http://www.socialengineer.us --