I agree, the dsp does a fine job and you can even change ctcss tones remotely if you like. K0JSC On Mar 6, 2013 9:40 AM, "Robert A. Poff WB3AWJ" <wb3awj@comcast.net> wrote:
If it were me, I'd just use the DSP and let it do the PL processing. In fact that's what I do on all our nodes. With no complains. Heck it can even do reverse burst on encode.
I'm not sure about the newer Com Spec decks, the the TS-32 had a high pass filter on board.
Robert A. Poff Loganville, PA.
**** "Lieutenant, target the offending power boat and launch photon torpedoes"
------------------------------ *From: *"Chris K7AZ" <kilo7AlphaZulu@verizon.net> *To: *"app rpt-users" <app_rpt-users@ohnosec.org> *Sent: *Wednesday, March 6, 2013 10:10:07 AM *Subject: *[App_rpt-users] Passing CTCSS / PL Tone Over The Network
Can anyone help me with eliminating passing CTCSS / PL tone from a receiver discriminator onto the network? I am using an URIx FOB with external ComSpec CTCSS / PL decoder and squelch gate COR. The 167.9 Hz CTCSS / PL tone is really noticeable while listening using IAXRPT and occupies 50% of the green bar graph. I realize adding a High Pass or Notch filter would help but is there a configuration setting change that will eliminate the tone? Thank you, Chris Hill K7AZ
_______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users
_______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users