Hello Gentlemen, I've been trying to get limey linux to work with some parallel ports. and it ain't working to what I think it should be. I'm using a Neoware CA-22 with 1GB RAM, 1GB flash and 1GHz processor. It boots and appears to run fine. I've configured it according to what K0KN and the info from ohnosec.org website. Something it not what it should be. There's always voltages on the parallel port pins I've specified in usbradio.conf. The voltage on pin 3 for ptt is at 2.4V and 4.8V on pins four and five. I have not run any commands on there to manually turn them on. When I run the command from the K0KN website to manually turn on the pin 3, the damn voltage still sits at 2.4V. When I run the command to turn it off, it still sits at 2.4V on that pin. Same thing for the other two pins. I don't understand why one of the GPIO pins sits at 2.4V and the other sit at 4.8V when the pins are set to be default off. Shouldn't the 'off' setting be zero volts, or something very close to zero? Below is what I added usbradio.conf for the parallel pins config: pp3 = ptt pp4 = out0 ;aux1 pp5 = out0 ;aux2 pp6 = out0 ;aux3 pp11 = cor Am I missing something? Something not correct? I'm rather disappointed the documentation is not very helpful in terms of what full configs should look like and the lack of references to teach new allstarlink dummies like me. ~Benjamin, KB9LFZ