Perfect, just what I was looking for. Adding to my living allstarlink notes for newbies.. Thanks! From: Scott Weis [mailto:kb2ear@kb2ear.net] Sent: Friday, July 22, 2011 9:57 AM To: 'Lu Vencl'; 'David KE6UPI' Cc: app_rpt-users@ohnosec.org Subject: RE: [App_rpt-users] My first node attempt today "radio active usbxxxxx" where xxxxx is your node number. "radio set debug" Should you everything about the RF side, COR detect, CTCSS detect, TX PTT, etc. From: app_rpt-users-bounces@ohnosec.org [mailto:app_rpt-users-bounces@ohnosec.org] On Behalf Of Lu Vencl Sent: Friday, July 22, 2011 9:49 AM To: 'David KE6UPI' Cc: app_rpt-users@ohnosec.org Subject: Re: [App_rpt-users] My first node attempt today Hi David, This is long fixed now.. Had an error in the USB.conf file, but what I was looking for was some sort of feedback showing DTMF detection, for which I now know I can see from CLI and perhaps a greater verbose value (I use 9) What would be nice though is COR status, for which I don't think there is any visual available that I know of.. But then again, I am using DSP now so it really does not matter. 73, Lu KA4EPS From: shawpbx@gmail.com [mailto:shawpbx@gmail.com] On Behalf Of David KE6UPI Sent: Friday, July 22, 2011 9:28 AM To: Lu Vencl Cc: app_rpt-users@ohnosec.org Subject: Re: [App_rpt-users] My first node attempt today Hey Lu, What command are you trying to use? I don't remember a command to show CTCSS or DTMF. I guess the questions is what are you trying to do? David On Sat, Jul 9, 2011 at 7:21 AM, Lu Vencl <vencl@att.net> wrote: Folks, Got the first one up, but I can't seem to get any command to work (unless I use CLI). Is there a script or method where I can get visual screen stats that shows CTCCS, DTMF decode etc? Similar to IRLP's read input? Thanks Lu KA4EPS _______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users