If you switch to a static IP then you must add a nameserver in the /etc/resolv.conf file. If you have a node setup with DHCP the name server will already be in the resolv.conf. But if you are static the resolv file gets cleared out. I ususally use an open dns like: nameserver 8.8.8.8 hope this helps. Jon VA3RQ On 10/11/2013 2:28 PM, Brett Friermood wrote:
I always just edit /etc/network/interfaces rather than using any built in utilities. It's especially helpful if you use different distributions across multiple platforms as it's all uniform.
No need to learn/use each distro's own utility, plus you can do exactly what you want instead of being limited by what the utility will let you do or will do without you knowing.
Like most things in Linux there is usually more than one way to do things and it comes down to personal preference.
Brett KQ9N
On Oct 11, 2013 10:24 AM, "Johnny Keeker" <cypresstower@yahoo.com <mailto:cypresstower@yahoo.com>> wrote:
there are two ways as [root@~] system-config-network setup upon change your settings, restart your network service, or reboot if you like ifconfig eth0 down ifconfig eth0 up (note) for those installing ACID for the first time, It's best to use DHCP Comments or Corrections are kindly accepted JK
*From:* VA3RZS <va3rzs@gmail.com <mailto:va3rzs@gmail.com>> *To:* Johnny Keeker <cypresstower@yahoo.com <mailto:cypresstower@yahoo.com>> *Sent:* Thursday, October 10, 2013 9:16 PM *Subject:* Re: [App_rpt-users] App_rpt-users Digest, Vol 56, Issue 20
What's the command to set the IP address
I have googled it and find 30 different ways
With red hat it was netconfig
But that command does not work in centos
Richard Szajkowski CMRK.NETworks (705)536-0769 <tel:%28705%29536-0769>
On Oct 10, 2013, at 8:31 PM, Johnny Keeker <cypresstower@yahoo.com <mailto:cypresstower@yahoo.com>> wrote:
At the least you have success. It takes about 10 minutes or less, when you first boot before your node reports to all the other on-linenodes. Some of my nodes use a static IP and others DHCP with reserved address. Let us all know how things work out for you. Good luck Richard JK
*From:* Richard Szajkowski <va3rzs@gmail.com <mailto:va3rzs@gmail.com>> *To:* Johnny Keeker <cypresstower@yahoo.com <mailto:cypresstower@yahoo.com>> *Sent:* Thursday, October 10, 2013 7:02 PM *Subject:* Re: [App_rpt-users] App_rpt-users Digest, Vol 56, Issue 20
I now have what I think is a working system ,
For some reason it fails if I put in a static IP , but if I run with DHCP it finds the mic and runs
If I tell it to pull down the info from the server for he node it dies
I need it on a static IP for port fowarding , just like my other VoIP systems
And I did do the info on the web portal to the best I can, I entered in all the info it requested
I even got to install your device now , this will be here Tuesday because of our long weekend
Thanks for all the help
Richard Szajkowski
On Oct 10, 2013, at 6:31 PM, Johnny Keeker <cypresstower@yahoo.com <mailto:cypresstower@yahoo.com>> wrote:
did you Not Create an installation disk???? I thought you were past that point and sitting at the test prompt If you completed the ACID install and got the test prompt the password is 'setup' once your in root type passwd and change it nodesetup.sh will run the script to push your node config files from the allstar server to your node "provided you created and saved the files prior to your ACID installation" JK
*From:* "zeppelin.1@netzero.com <mailto:zeppelin.1@netzero.com>" <zeppelin.1@netzero.com <mailto:zeppelin.1@netzero.com>> *To:* app_rpt-users@ohnosec.org <mailto:app_rpt-users@ohnosec.org> *Sent:* Thursday, October 10, 2013 5:20 PM *Subject:* Re: [App_rpt-users] App_rpt-users Digest, Vol 56, Issue 20
Hello Richard and welcome to the Linux world; You "must" do a CD BURN to the ISO for it to work properly, low speed is best for older CD ROM. 73 Anton/ KC2RQR Node 29103
---------- Original Message ---------- From: app_rpt-users-request@ohnosec.org <mailto:app_rpt-users-request@ohnosec.org> To: app_rpt-users@ohnosec.org <mailto:app_rpt-users@ohnosec.org> Subject: App_rpt-users Digest, Vol 56, Issue 20 Date: Thu, 10 Oct 2013 12:00:01 -0400
Send App_rpt-users mailing list submissions to app_rpt-users@ohnosec.org <mailto:app_rpt-users@ohnosec.org>
To subscribe or unsubscribe via the World Wide Web, visit http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users or, via email, send a message with subject or body 'help' to app_rpt-users-request@ohnosec.org <mailto:app_rpt-users-request@ohnosec.org>
You can reach the person managing the list at app_rpt-users-owner@ohnosec.org <mailto:app_rpt-users-owner@ohnosec.org>
When replying, please edit your Subject line so it is more specific than "Re: Contents of App_rpt-users digest..."
Today's Topics:
1. Help with new install (Richard Szajkowski)
----------------------------------------------------------------------
Message: 1 Date: Wed, 9 Oct 2013 18:14:55 -0400 From: Richard Szajkowski <va3rzs@gmail.com <mailto:va3rzs@gmail.com>> To: "app_rpt-users@ohnosec.org <mailto:app_rpt-users@ohnosec.org>" <app_rpt-users@ohnosec.org <mailto:app_rpt-users@ohnosec.org>> Subject: [App_rpt-users] Help with new install Message-ID: <B2A7C8C9-28C3-4A33-8F56-558F97D69D7D@gmail.com <mailto:B2A7C8C9-28C3-4A33-8F56-558F97D69D7D@gmail.com>> Content-Type: text/plain; charset=us-ascii
Hello to the group
I am trying to get the computer on line while my interface is shipped
I downloaded the ISO off the website , followed the prompts , I am not at a prompt Test >
I did not enter a root password as I was not asked
I can't find a PDF or anything on 1st time installs
Any help would be great
Thanks
Richard Szajkowski va3rzs
------------------------------
_______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org <mailto:App_rpt-users@ohnosec.org> http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users
End of App_rpt-users Digest, Vol 56, Issue 20 ********************************************* ____________________________________________________________ NetZero now offers 4G mobile broadband. Sign up now. <http://www.netzero.net/?refcd=NZINTISP0512T4GOUT1>
_______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org <mailto:App_rpt-users@ohnosec.org> http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users
_______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org <mailto:App_rpt-users@ohnosec.org> http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users
_______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org <mailto:App_rpt-users@ohnosec.org> http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users
_______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users