RXboost is set to 1. I will change it to 0 and report back. Interesting setting up the audio by generating the frequency and both a PL and 1000 Hz tone seemed to work ok. Just the rxnoise did not work. Thanks for your reply. Eric 4Z5UG From: Jim Duuuude [mailto:telesistant@hotmail.com] Sent: Monday, April 16, 2012 1:18 AM To: Eric Guth; app_rpt mailing list Subject: RE: [App_rpt-users] Set up URI rxnoise 4v pk-pk... unless you have "rxboost" set to "no" youre probably blowing its little brains out with so much signal. Jim WB6NIL ________________________________ From: eric@efratnetworks.com<mailto:eric@efratnetworks.com> To: app_rpt-users@ohnosec.org<mailto:app_rpt-users@ohnosec.org> Date: Sun, 15 Apr 2012 16:50:27 -0400 Subject: [App_rpt-users] Set up URI rxnoise Folks, I am Eric, 4Z5UG. I am setting up my first Allstar node using an URI to my Santec FM-240 2 meter transceiver. I am picking off discriminator audio from the radios receiver. I have 4 volts PtoP of noise with no carrier present. When I run the RXnoise test, it says that the "target is 27000", "tolerance 2750". My test measurement is 23000. I would think that 4 Volts p-p would be enough to get it right. Is there a way to change the target to put it in range of my noise output? 73, Eric, 4Z5UG _______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org<mailto:App_rpt-users@ohnosec.org> http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users