A couple of things. First in the node section of rpt.conf - the section where your node number is defined - you want this. morse=morse This second name could have an attached a label and could be defined differently like - morse=morse40961 where the numbers are your node number. In this case you do need to define the actual stanza with the correct name. And define your ID, of course with your call. The /L is optional. The call can be any valid CW letters, numbers or punctuation: idrecording=|iDE WA3DSP/L Also further down you will have this defined - [morse] speed=20 frequency=800 amplitude=4096 idfrequency=750 idamplitude=512 ; 1024 Make sure the amplitude is not too low. Here I have lowered it. Anything after a semicolon is a comment. Also the morse definition needs to follow the morse= definition shown above. 73 Doug WA3DSP http://www.crompton.com/hamradio Date: Mon, 3 Aug 2015 11:29:14 -0400 From: steves68@gmail.com To: App_rpt-users@ohnosec.org Subject: [App_rpt-users] CW id I never hear the CW id on the local side on my allstar node. Even when I press *80 I get nothing.What settings should I look at. I am sitting here looking at a printout of the rpt.cfg file. Any suggestions would be appreciated. Thanks, N4YOG Steve _______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users To unsubscribe from this list please visit http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users and scroll down to the bottom of the page. Enter your email address and press the "Unsubscribe or edit options button" You do not need a password to unsubscribe, you can do it via email confirmation. If you have trouble unsubscribing, please send a message to the list detailing the problem.