4v pk-pk... unless you have "rxboost" set to "no" youre probably blowing its little brains out with so much signal. Jim WB6NIL From: eric@efratnetworks.com To: app_rpt-users@ohnosec.org Date: Sun, 15 Apr 2012 16:50:27 -0400 Subject: [App_rpt-users] Set up URI rxnoise Folks, I am Eric, 4Z5UG. I am setting up my first Allstar node using an URI to my Santec FM-240 2 meter transceiver. I am picking off discriminator audio from the radios receiver. I have 4 volts PtoP of noise with no carrier present. When I run the RXnoise test, it says that the "target is 27000", "tolerance 2750". My test measurement is 23000. I would think that 4 Volts p-p would be enough to get it right. Is there a way to change the target to put it in range of my noise output? 73, Eric, 4Z5UG _______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users