Robert, Te stop hearing remote telemetry you just need to disable it. Add these lines to your rpt.conf under the functions stanza. [functions] it may read [functions28183] 901=cop,33 ; Local telemetry output enabled 902=cop,34 ; Local telemetry output disabled 903=cop,35 ; Local telemetry output timed Remote (when anybody connects/disconnects from xxxxx Only) You can also put that into your startup script to stop it from ever happening. [28183] startup_macro=*903# rxchannel = Radio/usb28183 ; Rx audio/ signaling channel If you ever want to re-enable it, just do a *901 Thank you, Fred McLean AllStar 29503 832-948-5200 From: mike@midnighteng.com [mailto:mike@midnighteng.com] Sent: Friday, January 17, 2014 7:23 PM To: App_rpt-users@ohnosec.org Subject: Re: [App_rpt-users] Telemetry Help You have no control of announcements from other nodes you are connected to. If you think about that, others telemetry is important to know if you are going to be connected to them. Otherwise, you could interfere with pending operations. ...mike/kb8jnm -------- Original Message -------- Subject: [App_rpt-users] Telemetry Help From: W2YMM <w2ymm1@gmail.com> Date: Fri, January 17, 2014 5:37 pm To: App_rpt-users@ohnosec.org Hello, I wanted to know if there is a way to shut off or limit announcements that I hear on my Allstar node. When connected to a large hub I very often hear "Remote Already In This Mode" and I'll hear when stations connect and Disconnect from each other, or if a call fails. I'd like to turn that off, but can't seem figure out where to do it. I looked at the Telemetry section here http://ohnosec.org/drupal/node/102 but It doesn't look like anything on my node.. At least in /etc/asterisk/rpt.conf Any help would be greatly appreciated. Thanks Robert Prybyzerski Jr W2YMM 631-960-1051 http://www.w2ymm.com Allstar 28183 _____ _______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users