On 9/22/18 1:05 PM, Ryan Gross wrote:
Group, Recent install of listed build. Asterisk GIT Version adaec47 built by root @ odroidxu4 on a armv7l │ running Linux on 2018-03-07 14:53:41 UTC
The problem I have ran into is when setting TX voice to 3.0 kHz I get a skipping of the tone. it goes away above 3.3 khc and below 2.9 kHz. the RX appears to be normal across the nodes I have connected to and save as expected.
You're saying you don't have the adjustment range from the software tuning values? I've seen this before, and the solution was always to pad it externally and get the adjustment in a more linear region of the set point. It's why I prefer the RA-40 adapters, no need to set the deviation in software.
I am using the Repeater- builder original RIM and where I has in previous version Dial of ASL installed for Raspberry pi the PL tone worked.out of TXmixB.
Well perhaps Kevin can chime in, but I don't think there was much different in his RIM.
Is something different ?
-- Bryan Fields 727-409-1194 - Voice http://bryanfields.net