I have one in las vegas thats doing the same thing and shutting the radio off as well! Used to happen once in a while, now happening a lot more...thinking it has to do with the 707G Sent from my piece of Crap I-Phone... I feel a Samsung 4 is in my near future On Jun 11, 2013, at 1:52 PM, Monty <monty@ke7jvx.com> wrote:
Hello Everyone,
I have tried two Kenwood G707s with three of Jim's URI Adapter cards and two URIs on two different computers. I am able to get three or four commands (freq, pl tone, etc) then I will get Allison saying "Invalid Frequency" and the CLI shows:
"WARNING[7925]: app_rpt.c:13876 serial_remote_io: -99999 Serial device not responding on node 1010"
The radio will not steer or accept commands anymore until I power cycle the 707. The after power cycle three or four commands and will not steer again. I have tried the same computer with a VHF Syntor with an xcat and will accept every command without issue. Also one of my 707s now lives on a Quad PCI card and steers with every command without issue. Has anyone else seen this or know the remedy? Below is my rpt.conf with the URI:
[1010] archivedir=/etc/asterisk/qso rxchannel = simpleusb/usb1010 duplex=0 ioport = /dev/ttyS0 remote = kenwood authlevel = 1 memory=memory remote_inact_timeout=5400 remote_timeout=5400 functions=remote-functions phone_functions=remote-functions link_functions=remote-functions
Monty KE7JVX _______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users