Hello everyone, I have finally got the ic-706 remote base partially working I can scan freq, move up in freq, and read status, Now that the commands also the init=freq..... works when I connect so it can set the frequency. just fine, yet if I do *1444*000*0... etc does not work If I do *0001 for memory 001 etc, I get 'memory not found' which the memory is in the rpt.conf [memory] ;Syntax : CC=RRR.RRR,PPP.P,AAAAA ; C=Channel Number ; R=RX Frequency ; P=PL Frequency ; A=Attributes ; ;Attributes : a=AM b=LSB f=FM u=USB ; l=Low Power m=Medium Power h=High Power ; -=Minus TX Offset s=Simplex +=Plus TX Offset ; t=TX PL on r=RX PL on ; 004=147.700,123.0,fshrt 005=147.100,123.0,fshtt 006=003.860,100.0,bshrt init=003.980,100.0,bshrt ;Set to this on startup This is just above the macro section below the functions-remote... At the end of the file I tried[memory] [memory] 001=147.700,123.0,fshrt 002=147.100,123.0,fshtt 003=003.860,100.0,bshrt None of these work, always says 'memory not found' Any ideas? I know I am getting close to making this work! 0=remote,1 ; Retrieve Memory 1=remote,2 Mark KC7DMF